fire

2 Biggest Mistakes When Building a Fire

From time to time, it happens that you do not devote enough time to set up a fire and this lack of focus and effort will result in issues to keep the fire burning.
A fire survives thanks to theĀ fire triangle (oxygen, heat and fuel): when one of these elements is missing, the fire goes out shortly.

If you’ve collected the right amount of tinder, kindling and well dried fuel wood, all you need to do is to obtain the right balance between air and heat. And now i’ll tell you the secret: you can find the right balance by leaving enough space (but not too much) between the logs.

Mistake #1: The Wood is Too Tight

If you’ve packed the wood too tight, it does not have sufficient oxygen to support the heat, therefore the temperature drops and the fire will go out.

Blowing air would keep your fire burning however it is a very inefficient way of managing your fire.

To correct this problem, try to create more space by pushing away the pieces with a green stick. To avoid completely the problem, make your fire over a green wood grid leaving an air space beneath the burning pieces.

Mistake #2: The Wood is Too Far Apart

If you place the logs too far apart, the heat is lost and the temperature is not sufficient to keep a fire burning.

To fix this issue, add kindling between the fire wood. As the kindling gets fire, put more kindling and then add wood fuel.

Sometimes you start with the appropriate distance but just because the wood is burning, the space will increase. Stoke the fire by moving the remaining wood closer or by adding more fuel.

 

Paying attention to the space between wood fuel before starting a fire and during its lifespan, you’ll avoid to waste your energy to light it again.

Remember: maintaining a fire is lot easier than starting a new one.

 

Leave a Reply

Your email address will not be published. Required fields are marked *