fires-structures

Top 4 Fire Structures

There are several methods that you should consider for laying a fire.

Tepee Method

To prepare a fire utilizing this method you should place the tinder and then the kindling and firewood in a conical structure. Light the tinder. The outer layer of logs will fall in feeding the fire. This approach is perfectly for using with wet wood.

Lean-to Method

Push a green stick directly into ground at a 30 degree angle. Point the tip of the stick wind. Place tinder deep within the lean-to stick. Position bits of kindling against the stick. Light the tinder. Be sure that you add more kindling as the kindling catches fire from the tinder.

Cross-Ditch

Scratch a cross in the earth. The cross really should be about 30 centimeters in dimensions. Dig the cross not less than 7 centimeters deep. Set a wad of tinder in the center of the cross. Making a pyramid of kindling above the tinder. The shallow ditch consent air to sweep under the tinder to supply a vital draft for the fire.

Pyramid

Position small branches or logs parallel on the soil. Next, place a layer of small wood steadily across the logs. Add three or four more layer of branches or logs. Each layer should be slightly smaller than the one below it. a starter fire directly on the top of the pyramid. The starter fire will ignite the logs below as the fire burns. This will offer you with a fire that will burn down and won’t absolutely need any thought throughout the night.

 


 

Leave a Reply

Your email address will not be published. Required fields are marked *